 |
Remove inspection cover on leading edge wing tank, 500mm from centre of strut fitting to out-board of wing. |
 |
Cut fuel vent line 6 inches from fuel tank fitting. |
 |
Fit rubber fuel line supplied with hose clamp to secure over first one inch of fuel vent line. |
 |
Drill hole in inspection cover and secure alloy fuel vent facing forward with rivets supplied then connect fuel line with hose clamp. |
 |
Secure inspection cover with fuel vent facing forward. |
 |
Tighten top brass fitting on existing fuel cap on top of both wings to eliminate any uneven fuel balance. |